Cómo se forma un enlace polipeptido?

Answer:

3. solids are measured in centimeters

4. gases And liquids are measured in milliliters

Answer:

Solids are measured in Mass

Gases and Liquids are measured in Volume

Explanation:

Solids can also additionally be measured by length as well.

fun fact: natural gas is measured by volume (cubic feet) but is sold based on its heating content (Btus). A cubic foot of natural gas is the amount of natural gas that can be contained in a cube one foot on a side, at a certain standard temperature and pressure. (source; oilgaslawyer blog)

Answer:

It takes six molecules of carbon dioxide and six molecules of water to make one molecule of glucose.

If a student notices that  one-quarter of the moon is visible, a lunar eclipse has taken place.

Eclipse is said to occur when one of the heavenly bodies casts a shadow on another heavenly body causing it to be partly visible or completely invisible. When the earth comes between the sun and the moon, a lunar eclipse is said to occur.

When a lunar eclipse occurs, the moon may be partly visible or completely invisible. Therefore, if a student notices that  one-quarter of the moon is visible, a lunar eclipse has taken place.

Learn more: https://brainly.com/question/6505878

Explanation:

At 25 °C Dissociation constant of water or Kw = 1× 10^-14 mol2dm-6

Ka × Kb = Kw for all diluted solutions

Ka×Kb = 1 × 10^-14 mol2dm-6

Therefore for question 1 -

COOH- is the conjugate base for HCOOH ( we find the conjugate base by removing an H atom and the Conjugate acid by adding an H atom)

COOH- (aq) + H2O ( l) <-----> HCOOH( aq) + OH-(aq)

So we can apply the above mentioned equation to find Kb value for COOH-

Kb = 5.56 × 10^-11 moldm-3

For question 2-

We can see that (CH3)2NH+2 is the conjugate acid of (CH3)2 NH. (A H atom has been removed so the one with a H atom less is the conjugate base.)

(CH3)2NH+2 (aq) + H2O (l) <-----> (CH3)2 NH (aq) + H3O+ (aq)

So applying the previously mentioned equation we get Ka = 1.85 × 10^-11 moldm-3

Explanation:

the investigation lasts for 7 days !

hope this helps you.

Answer:

We can do an experiment with vinegar to see what happens to the calcium in an eggshell when it is exposed to an acid.

Answer:

-85 °C

Explanation:

O and S are in the same group( Group 16). Since S is below O it's atomic mass is higher than O. So molar mass of H2S is higher than H2O. The strength of Vanderwaal Interactions ( London dispersion forces) increases when the molar mass increases. However, only H2O can form H bonds with each other. This is because electronegativity of O is higher than S and therefore H in H2O has a higher partial positive charge than H of H2S.

H bond dominate among these 2 types of forces so the strength of attractions between molecules is higher in H2O than H2S. Therefore more energy should be supplied for H2O to break inter

molecular forces and convert from solid to liquid state than H2S. So mpt of H2O must be higher than that of H2S.

Answer:

i dont speak mexican

Explanation:

Vectors may be plasmids. An example of one of several useful features of commercially prepared cloning vectors is MULTIPLE CLONING SITES.

The pUC18 vector is a widely used standardized cloning vector for replication in Escherichia coli.

A multiple cloning site can be defined as a short DNA fragment observed in genetically engineered plasmids.

These DNA fragments (multiple cloning sites) contain twenty (20) or more sites where restriction enzymes can cut in order to generate recombinant DNA molecules.

Learn more in:

https://brainly.com/question/14020637

Answer:

Mercury has a relatively high vapour pressure and the highest volatility of any metal, vapourizing to become a colourless, odourless gas. The metal is a fair conductor of electricity, but a poor conductor of heat. Mercury's atomic number is 8.

Answer:

The number by which we divide is called the divisor. The result obtained is called the quotient. The number left over is called the remainder.

Explanation:

Answer:

True.

Explanation:

Since electromagnetic radiation travels in waves, we can assume that the more high energy the waves are, the faster they will go. So therefore, higher energy travels faster.

Hope that helps you!

Answer:

True

Explanation:

Answer:

the answer would be B

Explanation:

The power from the charger use electricity and the electricity transforms to energy that can be moved

Using melting and boiling temperature, hardness and electric current passing testing.

Ionic solids are materials that have a strong bond between their ions, thus producing well-defined shapes.

In addition, due to this strong attraction, the boiling and melting temperatures of these materials are very high, in addition to the resistance to breakage presented by them.

Finally, ionic solids are also excellent conductors of electricity.

So, their properties used to determine whether or not they are ionic solids are  melting and boiling temperature, hardness and electric current passing testing.

Learn more about ionic solids: brainly.com/question/8236583

Answer:

Michal Faraday 19th century

The molarity of the acid, HCl solution is 0.103 M

We'll begin by calculating the number of mole in 0.2329 g of Na₂CO₃

Mass of Na₂CO₃ = 0.2329 g

Molar mass of Na₂CO₃ = (23×2) + 12 + (16×3) = 106 g/mol

Mole = mass / molar mass

Mole of Na₂CO₃ = 0.2329 / 106

Na₂CO₃ + 2HCl —> 2NaCl + H₂O + CO₂

From the balanced equation above,

1 mole of Na₂CO₃ reacted with 2 moles of HCl.

Therefore,

0.0022 mole of Na₂CO₃ will react with = 0.0022 × 2 = 0.0044 mole of HCl

Mole of HCl = 0.0044 mole

Volume = 42.87 mL = 42.87 / 1000 = 0.04287 L

Molarity = mole / Volume

Molarity of HCl = 0.0044 / 0.04287

Thus, the molarity of the acid, HCl solution is 0.103 M

Learn more: https://brainly.com/question/14600914

Explanation:

Mole ratio of NaOH : HCl = 1: 1

Moles of NaOH used = 0.1 mol/1000 cm3 × 27.20 cm3

= 2.72 × 10^-3 mol

Therefore moles of HCl used is also 2.72 × 10^-3 mol

So concentration of HCl can be found by dividing the no.of moles of HCl by the volume of HCl as follows

2.72 × 10^-3 mol/ 5cm3

1000cm3 = 1dm3

Therefore,

1cm3 = 1/1000 dm3

5cm3 = 5/1000 dm3

HCl conc. = 2.72 × 10^-3 mol/ 5×10^-3 dm3

= 0.544 moldm-3

Diamond is composed of hexagonal rings in which sp3 hybridized carbon atoms are linked together.

Hybridization refers to the mixing of atomic orbitals to yield hybrid orbitals that are suitable for bonding. The energy of orbitals that combine to form hybrid orbitals must be close enough for such combination to take place.

Diamond is composed of hexagonal rings in which sp3 hbridized carbon atoms are linked together. Each carbon atom in diamond is tetrahedral.

Learn more: https://brainly.com/question/967776

The mixing of the two different orbitals to form a compound is called hybridization. For example mixing of s and p orbits.

The correct answer is sp3.

The arrangement of the elements in a different manner to form a new compound is called allotropes. For example, diamond and graphite are the allotropes of carbon.

The valence electrons are in p orbitals and p orbit mixed after the s orbitals.

Therefore, the correct answer is sp3

For more information, refer to the link:--

https://brainly.com/question/3523174

Explanation:

A=Sun

B=Earth

C=Neptune.

hope my answer will definitely help you out.

Explanation:

Oils are made up of long hydrocarbon chains which are non polar. Since water is a polar solvent oil doesn't dissolve in water well.( Polar solutes dissolve in polar solvents and non polar solutes dissolve in non polar solvents) The hydrocarbon chains are hydrophobic.

The heat produced by 4.5 moles of magnesium when burnt is 2700 kJ.

A thermochemical reaction is a reaction in which the amount of heat lost or gained is included in the reaction equation. The thermochemical reaction equation for the combustion of magnesium is shown as follows;

2 Mg(s) + O2(g) → 2 MgO(s) + 1200 kJ

From the reaction equation;

2 moles of magnesium produced 1200 kJ of heat

4.5 moles of magnesium will produce 4.5 moles × 1200 kJ/2 moles

= 2700 kJ

Learn more: https://brainly.com/question/14281129

Answer:

The answer is option A

Explanation:

This is because the measure from crest to crest is also known as the wavelength, and the color of a wave always depends on its wavelength, if you see the electromagnetic spectrum

Hope this helps!

Answer:

New volume = 6.0L

Explanation:

Make a list of variables given in the question, and what we want to find:

Initial volume (L) = Vi = 3.1

Initial temperature (K) = Ti = 193

New temperature (K) = Tn = 374

New volume (L) = Vn

We have volumes and temperatures given and we're talking about gas, the equation including both these variables that should come to mind is the ideal gas equation:

PV = nRT

P = pressure (Pa)

n = number of moles

R = gas constant = 8.31

Now, we construct an equation we can solve to get the new volume:

P(Vn) = nR(Tn)

And insert the values we know:

P(Vn) = n(8.31)(374)

P(Vn) = n·3107.94

The equation contains 3 unknown variables;

We should first try to see if we can eliminate the 2 we are not interested in, namely P and n;

What we should recognise is that the pressure and number of moles will not change upon warming the balloon;

Firstly, heating the gas inside the balloon doesn't add anything to the balloon, i.e. doesn't increase the moles of gas, it simply raises the energy of the gas particles already within the balloon, so n will not change;

Secondly, I think there is a mistake in the question, it should read "assume constant pressure" in the brackets, since the temperature does change, which we are told;

Also, we can assume normal atmospheric pressure inside and outside the balloon as would be the case ordinarily;

What we want to do with this information is rearrange the equation we constructed to have these 2 constant or unchanging variables on one side and everything else on the other, so:

[tex]\frac{P}{n} = \frac{3107.94}{V_{n} }[/tex]

Next, we construct an equation for the balloon before warming:

P(Vi) = nR(Ti)

P(3.1) = n(8.31)(193)

P·3.1 = n·1603.83

Once again, rearrange to get P and n on one side of the equation and everything else on the other:

[tex]\frac{P}{n} = \frac{1603.83}{3.1} \\\\ \frac{P}{n} = 517.364516[/tex]

Now, we have two equations for P/n, we can eliminate P/n since both these values remain the same before and after warming the balloon as previously established:

[tex]\frac{3107.94}{V_{n} } = \frac{P}{n} = 517.364516 \\\\ \frac{3107.94}{V_{n} } = 517.364516 \\\\[/tex]

Now, rearrange and solve for Vn:

[tex]\frac{3107.94}{V_{n} } = 517.364516 \\\\ V_{n} = \frac{3107.94}{517.364516} \\\\ V_{n} = 6.00725...[/tex]

Vn = 6.0L

Answer:

bladder or bowel diseases, or arthritis. These might be your answer.

Explanation:

Electroplated jeweleries are in demand because firstly they are as shiny and attractive as real jeweleries, they are also light weighted and cost effective.

Answer:

composition of an element