when a car drives in a circle there must be ?

Answer:

I think it's D!!

cuz protons are in the atoms

Answer:

50m/s2

Explanation:

u=0m/s

a=10m/s

v=?

t=5s

v=u+at

=0+(10×5)

=0+50

=50m/s

A fixed mass of gas has a volume of 25 [tex]cm^3[/tex], the pressure of the gas is 100 kPa, the volume of the gas is slowly decreased by 15 [tex]cm^3[/tex] at a constant temperature, and the change in pressure of the gas is 150 kPa, which is option b.

PV = nRT (P= pressure of the gas, V =volume, n = number of moles of gas, R = gas constant, and T =temperature of the gas in kelvin)

Suppose the gas is an ideal gas and that the temperature is constant,

P1V1 = P2V2

Here P1 = 100 kPa, V1 = 25 [tex]cm^3[/tex], V2 = 10 [tex]cm^3[/tex],

100 kPa x 25 [tex]cm^3[/tex] = P2 x 10 [tex]cm^3[/tex]

P2 = (100 kPa x 25 [tex]cm^3[/tex]) / 10 [tex]cm^3[/tex]

P2 = 250 kPa

the change in pressure of the gas is,

ΔP = P2 - P1 = 250 kPa - 100 kPa = 150 kPa

The reason is that when the volume of a fixed mass of gas is decreased, the pressure of the gas increases proportionally, so here assuming that the temperature is constant it is calculated.

Hence, the volume of the gas is slowly decreased by 15 [tex]cm^3[/tex] at a constant temperature, and the change in pressure of the gas is 150 kPa, which is option b.

Learn more about the calculation of the change in pressure here.

https://brainly.com/question/15938504

#SPJ1

answer:

6 ohms

Explanation:

if these two resistors are connected in series, the total resistance is the sum: 2+4 = 6 (ohms)

Answer:

guard cell

hope it helps

Answer:

The water table is the upper surface of the zone of saturation. The zone of saturation is where the pores and fractures of the ground are saturated with water. It can also be simply explained as, the upper level, below which the ground is saturated.

Answer:

High in the atmosphere, air pressure decreases. With fewer air molecules above, there is less pressure from the weight of the air above. Places where the air pressure is high, are called high pressure systems. A low pressure system has lower pressure at its center than the areas around it.

Explanation:

Hope this helps you sorry if it doesn’t

Answer:

In many vibrating systems the frictional force Ff can be modeled as being proportional to the velocity v of the object: Ff = −cv, where c is called the viscous damping coefficient.

Answer:

It's B = Energy ....

i hope its right

Answer:

2

Explanation:

in reflection the incident ray and reflected rays are equal an angle

Answer:

250 kgm/s

Explanation:

To calculate momentum, simply take the product of the mass and velocity.

Answer: C or B

Explanation:

The EMF induced in the wire moving perpendicularly through a magnetic field is 0.025V. The correct option is C.

The EMF is the electro motive force which causes the current to induce in the object moving in the magnetic field.

Given is the length of wire L =15cm =0.15m, magnetic field strength B = 1.4T and velocity of wire V =0.12 m/s

EMF is related to the length of wire, magnetic field strength  and velocity of wire proportionally.

ε = B x L x V

Plug the values, we get

ε = 1.4 x 0.15 x 0.12

ε = 0.025 Volts

Thus, the correct option is C.

Learn more about EMF.

https://brainly.com/question/15121836

#SPJ2

Answer:

Q = 8608.8 J

Explanation:

Given that,

The mass of ice, m = 34 g

The temperature changes from -2°C to 118°C​.

The specific heat of ice, c = 2.11 J/g°C

The heat energy needed,

[tex]Q=mc\delata T\\\\Q=34\times 2.11\times (118-(-2))\\Q=8608.8\ J[/tex]

So, 8608.8 J of energy is needed.

Answer:

the positive charge is the period number

Explanation:

I might be wrong

Answer:

The positive charge is the group number.

Explanation:

Answer:

960 m

Explanation:

Given that,

We have to find the distance covered.

Firstly, let's convert time in seconds.

→ 1 minute = 60 seconds

→ 4 minutes = (4 × 60) seconds

→ 4 minutes = 240 seconds

Now, we know that,

→ Distance = Speed × Time

→ Distance = (4 × 240) m

→ Distance = 960 m

Therefore, distance covered is 960 m.

Answer:

5dhydydyeze6ese6z7zuezuze6ezyezyezzeze

Answer:

is from 9 x 107 m/sec to 27 x 107 m/s

1. Fermentation is a metabolic process that produces chemical changes in organic substrates through the action of enzymes. In biochemistry, it is narrowly defined as the extraction of energy from carbohydrates in the absence of oxygen. The science of fermentation is known as zymology.

2. In general, the longer that fermentation goes on, the more sugar is converted into alcohol, resulting in a less sweet (or “drier”) and more alcoholic beverage. To produce beer, various grains are used instead of grapes as the source of sugars. ... This drying process converts the starches present in grain into sugars

Answer:

1.) Fermentation, chemical process by which molecules such as glucose are broken down anaerobically. More broadly, fermentation is the foaming that occurs during the manufacture of wine and beer, a process at least 10,000 years old.

2.) In general, the longer that fermentation goes on, the more sugar is converted into alcohol, resulting in a less sweet (or “drier”) and more alcoholic beverage. To produce beer, various grains are used instead of grapes as the source of sugars. ... This drying process converts the starches present in the grain into sugars.

Explanation:

Answer:

Force = 3.591 * 10⁵ Newton

Explanation:

Given the following data;

Mass = 5.7 * 10⁶ kg

Acceleration = 6.3 * 10^-2 m/s²

To express the force as a scientific notation;

Force = mass * acceleration

Force = 5.7 * 10⁶ * 6.3 * 10^-2

Force = 359100 Newton

In scientific notation;

A number is said to be written in scientific notation when we multiply the numbers between 1 and 10 by a power of 10.

Force = 3.591 * 10⁵ Newton

Answer: vinegar

A heterogeneous mixture is a mixture in which the composition is not uniform throughout the mixture. ... A heterogeneous mixture consists of two or more phases. When oil and water are combined, they do not mix evenly, but instead, form two separate layers. Each of the layers is called a phase.

Hope it helps...

Answer:

Ions are formed by the addition of electrons to, or the removal of electrons from, neutral atoms or molecules or other ions; by combination of ions with other particles; or by rupture of a covalent bond between two atoms in such a way that both of the electrons of the bond are left in association with one of the ..

Answer:

Ions are formed when atoms lose or gain electrons, simply when electrons from the metal transfers electrons from its outermost shell( forming a positively charged metallic ion) to the outermost shell of the non-metallic atom( forming a negatively charged ion)

Answer:

Pascal Law's says that:

If the area of one end of a U-tube is A, and the area of the other end is A'. then if we apply a force F in the first end (the one of area A), the force experienced at the other end must be:

F' = F*(A'/A).

b) Now we can apply this to our particular case:

if the area of one end is 0.01m^2, and the area of the other end is 1m^2

Then we have:

A = 0.01m^2

A' = 1m^2

So, if now we apply a force F in the first end, the force experienced at the other end will be:

F' = F*(1m^2/0.01m^2) = F*100

This means that the force in the other end must be 100 times the force in the first end.

Answer:

One end of any bar magnet will always want to point north if it is freely suspended. This is called the north-seeking pole of the magnet, or simply the north pole. The opposite end is called the south pole.

Explanation:

Answer:

North Pole and South Poles

Explanation:

There is no east or west in a magnetic field of a magnet. The magnetic field lines comes from North pole to south pole.

Answer:

230

Explanation:

You do Ke = kinetic times distance divide by mass

Answer:

From the base unit of length, we can define volume, and from the base units of length, mass, and time, we can define energy. ... Volume. Since volume is length cubed, its SI derived unit is m3

Explanation:

Hope it helps

Answer:

Heat

Explanation:

The term heat refers to the conduction process which occurs when energy is passed between objects

Answer

Heat

did quiz and got it correct

Explanation:

Gravitational potential energy is energy an object possesses because of its position in a gravitational field. ... The gravitational potential energy is equal to its weight times the height to which it is lifted. PE = kg x 9.8 m/s2 x m = joules. The 9.8 us the gravitational acceleration constant.

so the answer is "the gravitational potential energy is decreasing"

Answer:

Distance = 30 meters

Explanation:

Given the following data;

Speed = 1.5 m/s

Time = 20 seconds

To find the distance travelled;

Speed can be defined as distance covered per unit time. Speed is a scalar quantity and as such it has magnitude but no direction.

Mathematically, speed is given by the formula;

[tex]Speed = \frac{distance}{time}[/tex]

Making distance the subject of formula, we have;

[tex] Distance = speed * time [/tex]

Substituting into the above formula, we have;

[tex] Distance = 1.5 * 20 [/tex]

Distance = 30 meters

Answer:

-148,6 MJ

Explanation:

Dado que la liberación de calor al medio ambiente es;

H = mcθ

Dónde;

m = masa de agua

c = capacidad calorífica específica del agua

θ = aumento de temperatura

H = 1220 kg × 4200 × [-29-0]

H = -148,6 MJ