Answer:
A. Energy is necessary for bond formation.
C. Breaking bonds takes energy.
D. When bonds are formed, energy is released.
Energy is always required for bond formation because when a chemical reaction occurs, either molecular bonds are broken or other bonds are formed to make different molecules. Energy is released during bond formation and is an exothermic process because bond formation represents a stable configuration and the energy lost is released as heat energy that makes it more stable. Breaking bonds takes energy and is an endothermic reaction because energy is absorbed to break bonds.
Hope that helps. x
Carbon has a half-life of 5,730 years and you found a fossil with 4 atoms of Carbon and 12 atoms of
Nitrogen, how old would it be?
a. 0 years old
b. 5,730 years old
c. 11,460 years old
d. 17,190 years old
Answer:
D. 17,190 years old
What is the pH of a solution with a 3.2 x 10−5 M hydronium ion concentration? (5 points)
Select one:
a.4.3
b.4.5
c.11
d.12
Answer:
b. 4.5
Explanation:
Since it is hydronium ion concentration, that means it is an acid.
pH formula = -log[H3O+]
-log(3.2 x 10^{-5} = 4.5
What is the mass of a 2.5 mole sample of MgO2
A quantity of 1.922 g of methanol (CH3OH) was burned in a constant-volume bomb calorimeter. Consequently, the temperature of the water rose by 4.20 Ce … lsius. If the heat capacity of the bomb plus water was 10.4 kJ/degree Celsius, calculate the molar heat of combustion of methanol
The formula for calculating the amount of energy or heat released is:
ΔH = C ΔT
where ΔH is heat of combustion, C is heat capacity, while ΔT is change in temperature
ΔH = 8.69 kJ / °C * (5.14°C)
ΔH = 44.67 kJ
Then we calculate the moles of CH3OH which has molar mass of 32.04 g/mol:
moles = 1.922 / 32.04 = 0.05999 mol
SO the molar heat of combustion is:
ΔHm = 44.67 kJ / 0.0599875 mol
ΔHm = 744.60 kJ / mol
how much sucrose can dissolve in 200g of water at 70 °C?
The maximum amount of a substance that can be dissolved in a solvent at a given temperature is referred to as its solubility.
Sucrose has a solubility of 320 g/100 g H2O at 70°C.
How is solubility usually measured?The equilibration of a suspension followed by an assessment of the solution composition, from which the solution concentration can be determined, is a widely accepted and accurate method for measuring solubility.The maximum amount of a substance that can be dissolved in a solvent at a given temperature is referred to as its solubility. This type of solution is known as saturated. To calculate the solubility in g/100g, divide the mass of the compound by the mass of the solvent and multiply by 100 g.The ability of a compound to dissolve in a liquid that functions as a solvent aids in the determination of the solubility test. The tests are critical because they determine the polarity of unknown compounds.Sucrose has a solubility of 320 g/100 g H2O at 70°C.
To learn more about : solubility.
Ref : https://brainly.com/question/23946616
#SPJ2
Explain why aluminum does not react with potassium nitrate (KNO3) although it reacts with copper nitrate
Answer:
Potassium is more reactive than aluminium, so no reaction takes place. But aluminium is more reactive than copper, so it replaces the copper in copper nitrate
Explanation:More reactive metal compound + less reactive metal
-> no reaction
However
Less reactive metal compound + more reactive metal
-> more reactive metal compound + less reactive metal
This is called substitution reaction where the more reactive metal replaces the less reactive metal in the compound.
Could a single person or animal be a point source pollution
Answer:
the main cause of pollution is mankinds work like gases and extreme heat caused by factories and cars and littering is also caused by people's careless throwing away so In term man kind is responsible for the pollution
Explanation:
which is the compound that has the higher boiling point and explain why we see the
differences we do
a. ethane vs. ethene
b. heptyne vs. pentyne
c. octane vs. octanal
thanks!
Answer:
b I think it is the correct answer
4. The new element Plainsmenium (Pe) was discovered in 2005 by Monte E. Rey
(who will receive his Nobel Prize in Chemistry in the year 2012). It has
three isotopes: Pe-184 (24.60%), Pe-185 (11.20%), and Pe-188 (64.20%).
What is its average atomic mass?
This is my answer
Explanation:
p=m/v
where:. p=density
m=mass
v=volume
p=F/A = Lim ∆F / ∆A
1 ATM=14.7 psi
= 1.013x10⁶ d/cm²
1 bar=10⁶ d/cm²
=10⁵ N/m2
Hope it helps to you goodluck
I'm not sure but that's the answer of my notebook like my answer please
what will happen to a person who doesn't recognize authors and even citing proper sources?
it will be called verbatim plagiarism, also called direct plagiarism
The results of Rutherford's gold foil experiment gave him the evidence to conclude that the center of an atom was A) called the nucleus. B) neutral and relatively small. C) positively charged and relatively small. D) a densely packed area containing both positive and negative particles.
Answer:
c)
Explanation:
because alpha particles can go through it
All of the following compounds are soluble in water EXCEPT
a
MgSO4
b
Ca(NO3)2
с
Agi
d
K2CO3
Answer:
Anser is C Agl
Explanation:
Agl does not dissolve in water.
All of the following compounds are soluble in water except AgI because of very high value of lattice energy. Therefore, the correct option is option C.
The capacity of a material, the solute, to combine with a different material, the solvent, is known as solubility in chemistry. Insolubility, or the solute's inability to create such a solution, is the opposite attribute. The concentration for the solute within a saturated solution—a solution where no more of the substance can be dissolved—is typically used to gauge the degree of a substance's solubility in a particular solvent. The two compounds are considered to be at the point of solubility equilibrium at this time. All of the following compounds are soluble in water except AgI because of very high value of lattice energy.
Therefore, the correct option is option C.
To know more about lattice energy, here:
https://brainly.com/question/29735933
#SPJ6
4.
TRUE OR FALSE?
Frequency is how often a wave occurs in a given time period.
Group of answer choices
True
False
Answer:
The answer to this question is True
I need help with this question.
The London forces designated as A are much weaker than the dipole- dipole interaction designated as B.
The intermolecular forces are interactions that exists between molecules of a substance in a particular state of matter. The nature of intermolecular forces in a substance greatly affect the properties of the substance.
We can see that A represents weak London forces while B represents dipole - dipole interactions. The London forces are very much weaker than the dipole - dipole interactions.
Learn more intermolecular forces: https://brainly.com/question/17111432
In general, people of __ heritage will be the last to get
white hair.
Answer:
African?
Explanation:
Seeds Roots Cones Stem Spores Leaves 1. Mongo 2. Moss 3. Ferns 4. Pine Tree 5. Guava 6. Mango 7. Coconut 8. Katakataka 9. Potato 10. Okra 14
The method of propagation of the given organisms is shown below:
1. Mongo ---> seeds
2. Moss ---> spores
3. Ferns ---> stem
4. Pine Tree ---> cones
5. Guava ---> seeds
6. Mango ---> seeds
7. Coconut ---> seeds
8. Katakataka ---> leaves
9. Potato ---> stem
10. Okra ---> seeds
Definition of reproductionRepr0duction is the process by which living organisms produce young ones of their kind.
Repr0duction can either involve two parents through the joining of male and female gametes to produce a zygote i.e. seeds in plants and embryo in animals or can involve only one parent and occurs through vegetative parts such as roots, stem, or leaves.
List of organisms and their propagation partsThe table below gives organisms and their propagation parts:
1. Mongo ---> seed
2. Moss ---> spores
3. Ferns ---> stem
4. Pine Tree ---> cones
5. Guava ---> seeds
6. Mango ---> seeds
7. Coconut ---> seeds
8. Katakataka ---> leaves
9. Potato ---> stem
10. Okra ---> seeds
Learn more about propagation and repr0duction at: https://brainly.com/question/13876478
Heart, 5 stars, and Brainiest to first right answer!
Nicole pushes her bike up a hill. Overhead, the sun exerts a gravitational force on Earth. Which statement is true about the bike and Earth?
A. They both experience contact forces.
B. They both experience non-contact forces.
C. The bike experiences a non-contact force and Earth experiences a contact force.
D. The bike experiences a contact force and Earth experiences a non-contact force.
Answer:
D. The bike experiences a contact force and Earth experiences a non-contact force.
Answer:D. The bike experiences a contact force and Earth experiences a non-contact force.
Explanation:
why is because tthe force wil make the bikw wobbly and boom no contact force
Heart, 5 stars, and Brainiest if right! Answer needed ASAP PLEASE!What type of forces do not change the motion of an object?
A. Acceleration forces
B. Balanced forces
C. Inertia forces
D. Unbalanced forces
Answer:
unbalanced force
Explanation:
pls mark me brainliest
Answer:
B. balanced forces
Explanation:
the motion of an object will not change if the forces pushing or pulling the object are balanced
How many liters are in a cubic meter? 100,000 100 10,000 1,000 10 NEXT QUESTION
1. Which of the following shows the process of freezing?'
A.candle wax cooling on the table
B.pouring cola over ice
C.heating a cup of water
D.particles are speeding-up and colliding more
_265Hs--->_16O+_9Be=_____?
Answer:
265hs+24.464536b+16o
Explanation:
265hs+16o+9b(2.718282)
=265hs+16o+24.464536b
=265hs+24.464536b+16o
Why is the same type of nail used in all test tubes? in every experiment done to show how rusting works and in what conditions.
in test tube 1 iron nail gets both air and moisture which is required for rusting. ... in the test tube 3 iron nail is not rusted because of the calcium chloride which is moisture absorber. hence nail would not get moisture for the rusting.
given the reaction 4Na(s) +O2 -> 2Na2O How many grams of Na2O can form from 3.0g of Na? use these molecular weight Na=23g/mole and O = 16g / mole
why is it important to use compound fixative in histology
Answer:
To prevent autolysis (enzymes attack) as well as putrefaction (bacterial attack) of tissues.
0.1216 g
wire
All
g
of
20 mL of 1M HCl
neutralized by addition of 50 mL of 0.20 M NaoH
Find the Atomic mass of Mg ?
added
magnisium was added
the excess
acid
was
Keep Scrolling! :D
[tex] \rule{999pt}{66646pt}[/tex]
The store paid 4.50 for a book and sold it for $7.65.what is the profit as a percent of the cost to the store? A. 3. 15% b. 58.8% c. 70% d. 315%
Answer: This would be C.) 70%
Explanation:
Which molecule does not obey the Octate rule of valence electrons .
BeCl2
FeCl2
CuCl2
ZnCl2
Explanation:
Which molecule does not obey the Octate rule of valence electrons .
BeCl2
FeCl2
CuCl2
ZnCl2
→BeCl2
Explaination:
BeCl2 violates the octet rule because the boron should be in a suitable valence state such that it binds to 3 chlorines. However, in this molecule boron is associated with six electrons.
Answer:
BeCl2
Explanation:
hope Its useful for you
[tex] \\ \\ [/tex]
kk
Electrolysis Is One of the Modern Technologies in Architecture’ Prepare an Investigatory Report That Supports the Statement”.
Electrolysis is a technique that separates natural elements. It is commercially used to obtain important materials (e.g., pure metals) for construction.
Electrolysis refers to the use of an electric current to trigger non-spontaneous chemical reactions.
This technology (electrolysis) is commercially important in industry, construction and therefore also in architecture in order to extract metals and minerals from the ground.
Electrolysis uses particular electrolytic cells in order to extract highly pure metals from ores.
Learn more about electrolysis here:
https://brainly.com/question/12054569
Answer: Electrolysis is a technique that separates natural elements. It is commercially used to obtain important materials (e.g., pure metals) for construction.
Electrolysis refers to the use of an electric current to trigger non-spontaneous chemical reactions.
This technology (electrolysis) is commercially important in industry, construction and therefore also in architecture in order to extract metals and minerals from the ground.
Electrolysis uses particular electrolytic cells in order to extract highly pure metals from ores.
Learn more about electrolysis here:
brainly.com/question/12054569
Which of the compounds, C4H10, BaSO4, Zn(CN)2, Al(OH)3, contain an anion with a -1 charge?
Answer:
b
Explanation:
OH and CN both have -1 charges
Which of the following is true about the mass of atoms?
А
An individual atom has no mass.
B
The atom of every element has a unique mass.
С
The mass of an atom increases with temperature,
D
The mass of an atom varies over time
Answer:
i think the answer is C , atom mass increases with temperature