An open top concrete tank is available to a construction crew to store water. The job site has a daily requirement for 500 gallons. The tank is 20’ in diameter and is 12’ deep is this tank large enough to meet the needs of the construction site? Note: a gallon of water has a volume of 1.33 cu ft.

Answer:

They are configured this way to avoid overlap issues.

Explanation:

Answer:

  $681.29

Explanation:

The amortization formula seems to apply. The monthly payment on a loan of P at rate r for t years is ...

  A = P(r/10)/(1 -(1 +r/12)^(-12t))

For the given loan parameters, the monthly payment is ...

  A = $60,000(0.065/12)/(1 -(1 +0.065/12)^(-12·10)) ≈ $681.29

The monthly payment is $681.29.

Answer: B.Idle relearn

Explanation:

When replacing an intake manifold gasket due to a vacuum leak, using a scan tool for idle relearn is a crucial step to complete the job. The Option B.

The scan tool is used to reset the idle control system and allow the engine's computer to relearn the correct idle speed and air/fuel mixture. This is important because the replacement of the intake manifold gasket can affect the engine's idle characteristics.

By using the scan tool to perform an idle relearn procedure, the engine management system can recalibrate and optimize the idle control parameters, ensuring smooth and stable idle operation. This step helps to restore the engine's performance and maintain proper combustion efficiency after the intake manifold gasket replacement.

Read more about scan tool

brainly.com/question/31196218

#SPJ2

Answer:

0.2 x 100

Explanation:

Engineering strain is the original crossection/original crossection

cold work percentage is

original crossection/original crossection x 100

Answer:

It's because to increase efficiency.

Explanation:

As electricity is transmitted over long distances, there are inherent energy losses along the way.

(I hope this will help)

These parts are commonly called carburetor emulsion tubes. These tubes maintain the air-fuel ratio at different speeds.

The carburetor is a device of the combustion engine power supply system that mixes fuel and air in order to facilitate internal combustion.

The carburetor emulsion tubes are tubes that maintain the air-fuel ratio at different velocities.

These tubes (carburetor emulsion tubes) are small brass cylinders where the metering needle slides into them.

Learn more about carburetors here:

https://brainly.com/question/4237015

Answer:

In digital electronics, a NAND gate (NOT-AND) is a logic gate which produces an output which is false only if all its inputs are true; thus its output is complement to that of an AND gate. A LOW (0) output results only if all the inputs to the gate are HIGH (1); if any input is LOW (0), a HIGH (1) output results.

Answer:

=4/5 because I'm not going to go back in a year meaning that they are you are

Neither technician Technician or  B is correct in the statement above.

Vibration is a factor that is said to be caused by one or more other factors that occur together at any given time.

This can be due to actors such as imbalance, misalignment, wear and looseness and others. An imbalance  occurs due to  a "heavy spot" that is found inside a rotating component and it will lead to vibration when the unbalanced weight is said to rotates in circles round the machine's axis.

Learn more about  primary vibration from

https://brainly.com/question/7228243

Answer:

The ratio of water to flour needed to make tortillas, which is 3 : 4

Explanation:

100 w = 75 f

w/f = 75/100 = 3/4

Answer:

There are many life-saving benefits of biotechnology.

Explanation:

Answer:

Full wave rectification flips the negative half cycle of the sine wave to positive so the result is two positive half cycles.

Explanation:

hope it helps a lil

Answer:

1

1What is the output of 2 Input XNOR gate if both the inputs are same? Explanation: The output of 2 Input XNOR gate is 1 if both the inputs are same. The output of the XNOR gate is 1 if both the inputs are logic 0 or logic 1. This is why they are called as equality detector.

Answer:

The OR gate is a digital logic gate that implements logical disjunction (∨) from mathematical logic – it behaves according to the truth table above. A HIGH output (1) results if one or both the inputs to the gate are HIGH (1). If neither input is high, a LOW output (0) results.

ANSWER :

325

Explanation:

313 + 12 = 325

Answer:

convenction is your answer

Answer:

Last one

Explanation:

I took the test

Answer:

B. To accurately measure spark advance, use a timing light that incorporates an

ignition advance meter. The spark advance cannot be determined by listening to the way the engine sounds.

Answer:

buter uwu heheheheh joke

Answer:

You forgot the image and or example. I mean the answer could be anything right now.

The friction loss in the system is 3.480 kilowatts.

Let suppose that the pump within a distribution system is an open system at steady state, whose mass and energy balances are shown below:

[tex]\dot m_{in}-\dot m_{out} = 0[/tex] (1)

[tex]\dot m_{in} = \frac{\dot V_{in}}{\nu_{in}}[/tex] (2)

[tex]\dot m_{out} = \frac{\dot V_{out}}{\nu_{out}}[/tex] (3)

[tex]\eta \cdot \dot W_{el} + \dot m_{in}\cdot (h_{in}-h_{out}) - \dot W_{f} = 0[/tex] (4)

Where:

From steam tables we get the following water properties at inlet and outlet:

Inlet

[tex]p = 100\,kPa[/tex], [tex]T = 25\,^{\circ}C[/tex], [tex]\nu = 0.001003\,\frac{kJ}{kg}[/tex], [tex]h = 104.927\,\frac{kJ}{kg}[/tex], Subcooled liquid

Outlet

[tex]p = 300\,kPa[/tex], [tex]T = 25\,^{\circ}C[/tex], [tex]\nu = 0.001003\,\frac{kJ}{kg}[/tex], [tex]h = 105.128\,\frac{kJ}{kg}[/tex], Subcooled liquid

If we know that [tex]\dot V_{in} = 0.05\,\frac{m^{3}}{s}[/tex], [tex]\nu_{in} = 0.001003\,\frac{m^{3}}{kg}[/tex], [tex]h_{in} = 104.927\,\frac{kJ}{kg}[/tex], [tex]h_{out} = 105.128\,\frac{kJ}{kg}[/tex], [tex]\eta = 0.90[/tex] and [tex]\dot W_{el} = 15\,kW[/tex], then the friction loss in the system is:

[tex]\dot W_{f} = \frac{\dot V_{in}}{\nu_{in}}\cdot (h_{in} - h_{out}) + \eta \cdot \dot W_{el}[/tex]

[tex]\dot W_{f} = \left(\frac{0.05\,\frac{m^{3}}{s} }{0.001003\,\frac{m^{3}}{kg} } \right)\cdot \left(104.927\,\frac{kJ}{kg}-105.128\,\frac{kJ}{kg}\right) + (0.90)\cdot (15\,kW)[/tex]

[tex]\dot W_{f} = 3.480\,kW[/tex]

The friction loss in the system is 3.480 kilowatts. [tex]\blacksquare[/tex]

To learn more on pumps, we kindly invite to check this verified question: https://brainly.com/question/544887

Answer:

The output we get from a full-wave rectifier is a pulsating DC voltage that increases to a maximum and then decreases to zero.

Explanation:

hope it helps sorry if im wrong

The separation and purification process is used for DEVELOPING VACCINES. The development of vaccines must follow strict guidelines.

A vaccine is a biological preparation used to protect against harmful diseases (e.g., viruses) in a simple and safe manner.

Vaccine purification is a strict process consisting of clarification, concentration and chromatography in order to separate the extract that contains the active principle of the vaccine.

The techniques used for vaccine filtration include membrane filtration, depth filtration and centrifugation.

Learn more about vaccines here:

https://brainly.com/question/6683555

Answer:

a naturally occurring solid material from which a metal or valuable mineral can be profitably extracted.

Explanation:

yw

Answer:

Ore is an accumulation of any mineral mixed with other elements. The mineral content of an ore must be in sufficient concentration to make its extraction commercially and economically viable.

Hope it helps.

If you have any query, feel free to ask.

Answer:

z=X=c+J=A

Explanation:

Robert Hooke contributed a full description of living cells to the field of bioengineering

So, Robert Hooke contributed a full description of living cells to the field of bioengineering.

Learn more about robert hooke here:

https://brainly.com/question/24915231