I need help with the balancing one

Answer:

When you place an iron nail in a basin of water and leave it for two days, what will happen to the iron nail? It will form rust on the surface of the nail. Rust forms when iron combines with oxygen to form iron oxide.

Explanation:

Assuming they were clean of rust to begin with, and are made of an ordinary steel - they start to rust - will turn orange, and the orange sediment...

Not much if any while it's in the water for that period of time. However once you remove it then it will be exposed two oxygen and will start to ox...

If it is not coated properly It will form Rust .

Answer:

Metal

Explanation:

Answer:

pH strips and written observations of stream water

Explanation:

Answer:

calcium is the correct answer :)

Answer: The answer is C

covalent bonds have a lower melting and boiling point

HOPE THIS HELPS !! IF YOU NEED MORE HELP FEEL FREE TO COMMENT IN THE COMMENT SECTION

Answer:

three atoms = 1 water molecule

3 × 6 = 18 atoms

................

Answer:

physical- torn paper, coloring leaves in a coloring book

chemical- burned paper, leaves turning colors during fall and winter

Explanation:

Answer:

[tex]MgCl_{2} O_{4}[/tex]

Explanation:

When calculating an empirical formula from percentages, assume you have a 100g sample. This allows you to convert the percentages directly to grams, because X % of 100g is X grams.

So:

15.3 % = 15.3g Mg, 44.5% = 44.5g Cl, 40.2% = 40.2g O

The next step is to divide each mass by their molar mass to convert your grams to moles.

15.3/24.3 = .630 mol

44.5/35.5 = 1.25 mol

40.2/16.0 = 2.5 mol

Then you will divide all of your mol values by the SMALLEST number of moles. This gives you whole numbers that are the mole ratio (subscripts) of the empirical formula.

.630 mol/.630mol = 1

1.25 mol/.630mol = 2

2.5 mol/.630mol = 4

So the empirical formula is

[tex]MgCl_{2} O_{4}[/tex]

“Many of the objections are long standing but apparently unknown to many geophysicists, while some are peculiar to the new global tectonics. The conclusions drawn, in order of probability, are (1) the continents have almost certainly not moved with respect to each other; (2) convection is not active throughout the whole mantle; (3) even if convection is active in the upper mantle it cannot account for drift; (4) pole positions derived from paleomagnetism, and results of this method of investigation in its global form generally, are afflicted with an unknown cause of error and are in any case too inexact for drift reconstructions.”

(Wesson, 1972)

Answer:

2Ga(OH)3 + 3Hg2Cl2 → 6Hg(OH) + 2GaCl3

Explanation:

Answer: 2Ga(OH)3 + 3Hg2Cl2 → 6Hg(OH) + 2GaCl3

reaction type: Double Displacement

Answer:

due to the law of conservation of mass, the mass would stay the same.

Answer:

A: 0.67

The situation described in the question is analogous to a semipermeable membrane. Water is able to pass through aquaporin channels present in the liposome, but large uncharged particles (glucose) and ions (K+ and Cl -) are impermeable and will remain trapped within the liposome. If assumed to be ideal, the osmotic pressure, π, exerted by the solution due to molarity differences across the membrane is defined as π = iMRT, where i is the van't Hoff factor, M is the molarity of the solution, R is the universal gas constant, and T is the absolute temperature of the solution. A change in osmotic pressure at constant temperature is due to changes in iM, a term that is equivalent to the concentration of dissolved particles produced by solute in solution. When compared to the original volume of 1 M glucose, the new combined solution has twice the volume and three times the number of dissolved particles (1 M KCl, a strongly electrolytic solution, produces 1 M concentrations of both K+ and Cl- in solution), or an increase in the concentration of dissolved particles by a factor of 1.5. This is equivalent to a combined molarity of dissolved particles of 1.5 M. The ratio of osmotic pressure is then [1 M dissolved glucose] / [1.5 M dissolved glucose + KCl] = 0.67

Explanation:

Answer:

1.79 moles

Explanation:

1.79 moles

1.79 moles

1.79 moles

1.79 moles

Answer:1.79 moles

1.79 moles are there in 100g of iron.

Explanation:

thats the answer for it

Answer:

The mass number

Explanation:

The mass number of an atom is its total number of protons and neutrons.

I hope this helps a bit.

Answer:

Atomic size decreases on going along a period from left to right because the electron enters into the same shell, therefore, attraction between nucleus and outermost electron increases and thus atomic size decreases. Valency first increases from 1 to 4 and then decreases from 4 to GO along a period from left to right.

Answer:

kha gya vo chasmis ........

Answer:

1.031atm

Explanation:

Answer:

The cell goes through the cell cycle/mitosis

Explanation:

The cell cycle is basically the process of dividing

G1 phase is where the cell grows in size, and make sure that everything is ready to divide.

Synthesis or the S phase is where the cell copies its DNA.

G2 phase is where the cells check that all its DNA has been correctly copied.

Mitosis or M phase, where the cell finally divides in two. If the cells keep on dividing exponentially, they will become billions of cells.

Answer:

2.77 atm

Explanation:

The total pressure of a mixture of gases is calculated as the addition of the partial pressures of the gases. In this case, the total pressure (Pt) is calculated from the partial pressures of helium (PHe), nitrogen (PN₂) and neon (PNe):

Pt = PHe + PN₂ + PNe

First, we have to convert the partial pressures to the same unit (atm). For this, we have to know that 1 atm=760 mmHg=760 Torr

PHe = 585 mmHg x 1 atm/760 mmHg = 0.77 atm

PN₂= 0.76 atm

PNe= 940 Torr x 1 atm/760 Torr = 1.24 atm

Finally, we calculate the total pressure in atm:

Pt = 0.77 atm + 0.76 atm + 1.24 atm= 2.77 atm

Answer:

photosynthesis

Explanation:

took the test

Answer:the answer is a

Explanation:

The density of a gas at standard temperature and pressure conditions is 1.40 grams per liter.

Standard temperature and pressure are defined as a standard set of conditions required for experimental measurements which are established to allow comparison between different sets of data.

Standards which are commonly used are those International Union of pure and applied chemistry and national institute of standards and technology.These are not universally accepted standards but are the ones which are commonly used.

Standard conditions of pressure and temperature are necessary to define standard reference conditions used to express volumes of liquids and gases.These values are important to physicists, chemists ,engineers ,pilots and navigators.

Learn more about standard temperature and pressure,here:

https://brainly.com/question/29129606

#SPJ5

Answer:

The main difference between Mendeleev and Modern Periodic Table is that Mendeleev’s periodic table orders the elements based on their atomic mass whereas Modern periodic table orders the elements based on their atomic number.

Explanation:

Answer:

substance

Explanation:

A pure substance is a form of matter that has a constant composition (meaning it's the same everywhere) and properties that are constant throughout the sample (meaning there is only one set of properties such as melting point, color, boiling point, etc

Answer:

concave

Explanation:

Answer:

You will need to have a red flower in the top left, a pink flower in the top right and bottom left, and a white flower in the bottom right.

Explanation:

This flower appears to express color through codominance, which means that both genes express themselves. "R" is the dominant gene for red, and "r" is the recessive gene for white. When a flower has RR genotype, the phenotype will be a red flower. When a flower has an Rr genotype, the red and white genes will both be expressed and the phenotype will be pink. When a flower has an rr genotype, it lacks the red gene and will therefore be only white.

Answer:

False

Explanation:

Answer:

true

Explanation:

i dont know if you want more info on how it is true just tell me if you do and i will add it in