Interpret the following graphs by answering the questions below.
a. The figure below shows the Standing waves
How many nodes and antinodes?

Answer:

Load = 80 Newton

Explanation:

Given the following data:

Effort = 20 N

Load arm = 15 cm

Effort arm = 60 cm

Conversion:

100 cm = 1 meters

15 cm = 15/100 = 0.15 meters

60 cm = 60/100 = 0.6 meters

To calculate the load, we would use the expression;

Effort * effort arm = load * load arm

Substituting into the expression, we have;

20 * 0.6 = load * 0.15

12 = load * 0.15

Load = 12/0.15

Load = 80 Newton

Answer:

Explanation:

The gravitational force equation is

[tex]F_g=\frac{Gm_1m_2}{r^2}[/tex] where G is the gravitational constant. Filling in with what we are given and what we know to be true:

[tex]F_g=\frac{6.67*10^{-11}(59)(59)}{(2.0)^2}[/tex] which, when you do the math, comes out to be

[tex]F_g=5.8*10^{-8}N[/tex], choice A.

Answer:

Moment is an expression involving the product of a distance and physical quantityA moment is due to a force not having an equal and opposite force directly along it's line of action. ... It is defined as the product of the force (F) and the moment arm (d). The moment arm or lever arm is the perpendicular distance between the line of action of the force and the center of moments.Moments act about a point in a clockwise or anticlockwise direction.

Answer: A ( how to pedal and balance )

Explanation:

Answer:

Photosynthesis converts solar energy into chemical energy.

your answer is solar energy

hope it helps

Answer:

  (D)  4

Explanation:

The percentage error in each of the contributors to the calculation is 1%. The maximum error in the calculation is approximately the sum of the errors of each contributor, multiplied by the number of times it is a factor in the calculation.

  density = mass/volume

  density = mass/(π(radius^2)(length))

So, mass and length are each a factor once, and radius is a factor twice. Then the total percentage error is approximately 1% +1% +2×1% = 4%.

_____

If you look at the maximum and minimum density, you find they are ...

  {0.0611718, 0.0662668} g/(mm²·cm)

The ratio of the maximum value to the mean of these values is about 1.03998. So, the maximum is 3.998% higher than the "nominal" density.

The error is about 4%.

_____

Additional comment

If you work through the details of the math, you will see that the above-described sum of error percentages is just an approximation. If you need a more exact error estimate, it is best to work with the ranges of the numbers involved, and/or their distributions.

Using numbers with uniformly distributed errors will give different results than with normally distributed errors. When such distributions are involved, you need to carefully define what you mean by a maximum error. (By definition, normal distributions extend to infinity in both directions.) While the central limit theorem tends to apply, the actual shape of the error distribution may not be precisely normal.

Answer:

Explanation:

#CARRYONLEARNING

justoko2

Answer:

D. Energy in an isolated system remains constant.

Explanation:

Energy can be defined as the ability (capacity) to do work. The two (2) main types of energy are;

a. Gravitational potential energy (GPE): it is an energy possessed by an object or body due to its position above the earth.

b. Kinetic energy (KE): it is an energy possessed by an object or body due to its motion.

Furthermore, the various forms of energy are solar energy, electrical energy, chemical energy, thermal energy, wind energy, nuclear energy etc.

The Law of Conservation of Energy states that energy cannot be destroyed but can only be transformed or converted from one form to another.

According to the law of conservation of energy, we can infer or deduce that the total energy of the system must stay the same because it cannot be destroyed, but kinetic energy (KE) can be transformed to potential energy (PE) and potential energy (PE) can be transformed to kinetic energy (KE) within the system.

Answer:

a.

[tex]F=G\cdot\dfrac{M \cdot m}{r^{2}}[/tex]

b.

[tex]F=6.67430 \times 10^{-11} \dfrac{N \cdot m^2}{kg^2} \times \dfrac{5.97 \times 10^{24} \ kg \times 1,300 \ kg}{(6,578 \ m)^{2}}[/tex]

c.

[tex]F=6.67430 \times 10^{-11} \dfrac{N \cdot m^2}{kg^2} \times \dfrac{5.97 \times 10^{24} \ kg \times 1,300 \ kg}{(6,578 \ m)^{2}} \approx 1.144 \times 10^{13} \ N[/tex]

d. The force of gravity acting on the satellite is approximately 1.144 × 10¹³ N

Explanation:

a. The formula for finding the force of gravity, F, acting object on an object is given as follows;

[tex]F=G\cdot\dfrac{M \cdot m}{r^{2}}[/tex]

Where;

F = The force acting between the Earth and the object

G = The gravitational constant = 6.67430 × 10⁻¹¹ N·m²/kg²

M = The mass of the Earth = 5.97 × 10²⁴ kg

m = The mass of the object

r = The distance between the center of the Earth and the object

b. Finding the gravitational force, 'F', between the Earth and the scientific satellite, we have;

The given mass of the satellite, m = 1,300 kg

The distance between the center of the Earth and the center of the satellite,  r = The length of the radius of the Earth + The height of orbit of the satellite

The given height of orbit of the satellite, h = 200 km

∴ r = R + h = 6,378 km + 200 km = 6,578 m

Therefore, by plugging in the values, we get;

[tex]F=6.67430 \times 10^{-11} \dfrac{N \cdot m^2}{kg^2} \times \dfrac{5.97 \times 10^{24} \ kg \times 1,300 \ kg}{(6,578 \ m)^{2}}[/tex]

c. Solving the above equation gives;

[tex]F=6.67430 \times 10^{-11} \dfrac{N \cdot m^2}{kg^2} \times \dfrac{5.97 \times 10^{24} \ kg \times 1,300 \ kg}{(6,578 \ m)^{2}} \approx 1.144 \times 10^{13} \ N[/tex]

d. The force of gravity acting on the satellite, F ≈ 1.144 × 10¹³ Newton

Answer:

Pressure = ρgh

pressure (p) is measured in pascals (Pa)

density (ρ) is measured in kilograms per metre cubed (kg/m3)

The fore of gravitational field strength (g) is measured in N/kg or m/s 2

height of column (h) is measured in metres (m)

Answer = 235,200 Pa

Explanation:

Pressure = ρgh

Pressure = 1,000 x 9.8 x 24

Pressure = 235,200 Pa

Answer:

-mg = -7.52*9.8 = - 73.696N

Answer:

See image

Explanation:

Plato

A.brass is heavier than water.

Answer:

All of them are false

Explanation:

4. electrons flow from earth to the object

5. electrons move freely

6. protons can't move

Answer:

They all false

Answer:

Fundamental unit is any unit that is not dependent on other units and other units can be derived from them

Explanation:

Units such as Kilogram, Mass and Time are said to be fundamental units because they are independent.

Differences between Mass and weight;

1. Mass is the measure of the amount of matter in a body while weight is a measure of how the force of gravity acts upon that mass.

2. Mass is a scalar quantity while weight is a vector quantity

Answer:

A

Explanation:

the object's mass determines the speed of the object and its kinetic energy

Answer:

The teddy bear did not stop at the same time as the car because of inertia.

Explanation:

The teddy bear did not stop at the same time as the car because of inertia.

Inertia is a resistance of an object to change its state of motion so if an object is moving it will continue the movement until a force act on it, and vice-versa if an object is at rest it will continue in that state until a force act on it.              

Hence, when the teddy bear was in the back seat and the car suddenly stops, the teddy kept moving forward because that was the direction of motion of the car (the teddy bear was moving forward with the car). The force of the brakes acts on the car but not on the teddy bear (not directly), that is why this force does not change the state of motion of the teddy bear.                     

Therefore, the teddy bear did not stop at the same time as the car because of inertia.

I hope it helps you!                    

Answer:

C. A sock sticks to a pair of pants after both are removed from the

clothes dryer.

Explanation:

there is influence of charges

Answer:

False

Explanation:

I'm not the most sure but it seems reasonable that it's false

Good Luck Bestie :3

Answer:

The answer is false. If you want why. I will desxribe you.

Answer:

B. Uranium 238.

Explanation:

It is radioactive and can be used to treat cancer in the form of radiotherapy

Answer:

a region around a magnetic material or a moving electric charge within which the force of magnetism acts.

Explanation:

The definition of a magnetic field is a place in space near a magnet or an electric current where a physical field is created from a moving electric charge that creates a force on another moving electric charge. An example of a magnetic field is the Earth's magnetic field.

Answer:

The human body runs at a constant 37 ºC but the air around you at room temperature is about 20-25 ºC which means heat is constantly leaving your body to warm your surroundings and maintain thermal equilibrium. You don't lose much energy doing this however as air heats reasonably quickly

Explanation:

Answer:

Consequently the statement is FALSE

Explanation:

The process of emission of electrons or photoelectric effect, was explained by Einstein, assuming that light behaves as formed by how many so-called photons and each one of them collides with an electron, therefore to start an electron the incident photon energy must be greater than the work function of the material.

            E =K + Ф

By mentioning the intensity we increase the number of photons but we do not increase their energy.

Consequently the statement is FALSE

Answer:

34902

Explanation:

Pv=nRt

v=nrt/p

subsitute

v=15*831*280/100

v=34902

Answer:

electron

Explanation:

The electron is the subatomic particle with the least mass. Therefore option A is correct.

Both protons and neutrons have significantly larger masses compared to electrons.

The mass of an electron is approximately 9.1 x 10^-31 kilograms, while the mass of a proton is about 1.67 x 10^-27 kilograms, and the mass of a neutron is also around 1.67 x 10^-27 kilograms.

It's important to note that the "atom" is not a subatomic particle but a structure composed of subatomic particles. An atom consists of a nucleus (composed of protons and neutrons) and electrons orbiting around the nucleus.

The mass of an atom depends on the number of protons, neutrons, and electrons it contains, so it can vary widely depending on the specific atom.

In summary, when comparing individual subatomic particles, the electron has the least mass.

Know more about electrons:

https://brainly.com/question/1255220

#SPJ7

Answer

225 meters.

Explanation:

x=x0+30t-(1/2)(1.5)t^2

x=0+30(10)-(1/2)(1.5)(10)^2

x=300-75

x=225

Answer:

Energy is: the ability to do work

The formula for energy is: power x time = energy

Explanation:

Hope this helps (there isn't really an explanation)

Answer:

True.

This is because, from the information provided so far, it could be concluded that, the policy makers don't have any single idea of what they are doing regarding to the economy.

This could be seen in the series of poor performance of the economic indicators as shown which has lead to poor economic growth in our country.

Explanation:

Answer:

It is because some of the heat is lost in the surroundings.

Explanation:

To calculate the specific heat of the metal, the following steps are performed.

Take a piece of metal whose mass and the initial temperature is known.

Now take a beaker filled with some measured amount of water and the temperature of water is known.

Drop the heated metal piece in the water so that the equilibrium is reached.

According to the principle of calorimetery,

Heat lost by the metal = heat gained by the water

here, some of the heat is lost in the surroundings so we don't get the correct value of the specific heta of the metal.

Answer:

amu is atomic mass unit

All of elements hydrogen is the lightest.

Hydrogen is taken as a basic unit so it happened 1amu

So 1 amu must be hydrogen mass

If I am wrong,Pls tell me the true answer....

Answer:

40 m

Explanation:

The area under v-t graph gives the distance travelled by the particle.

Distance = area of ΔOBC + area of ΔCDE + area of ΔEFG

[tex]=\dfrac{1}{2}\times 4\times 10+\dfrac{1}{2}\times 2\times 10+\dfrac{1}{2}\times 4\times 5\\\\=40\ m[/tex]

So, the distance travelled by the particle in the time interval t = 0 and t= 10 s is equal to 40 m.

Answer:

Force = 12.5 Newton

Explanation:

Given the following data;

Mass = 250 g to kilograms = 250/1000 = 0.25 kg

Acceleration = 50 m/s²

To find the force;

Newton's Second Law of Motion states that the acceleration of a physical object is directly proportional to the net force acting on the physical object and inversely proportional to its mass.

Mathematically, it is given by the formula;

[tex] Acceleration = \frac {Net \; force}{mass} [/tex]

Making force the subject of formula, we have;

[tex] Force = mass * acceleration [/tex]

Substituting into the formula, we have

[tex] Force = 0.25 * 50 [/tex]

Force = 12.5 Newton