The total weight of both objects : 7.035 x 10⁻⁸ kg
Further explanationGiven
The weight of a grain of sand : 3.5 x 10⁻¹⁰ kg
The weight of one hair from his eyebrow : 7 x 10⁻⁸ kg
Required
The total weight of both objects
Solution
Scientific Notation consists of 2 parts
1. the first part: the first digit followed by the decimal point
2. The second part: the power of 10 (the exponents).which shows the number of digits after the decimal point
To add/subtract, the exponents must be the same and then add/subtract the coefficient
convert the largest exponent (7 x 10⁻⁸)7 x 10⁻⁸ = 700 x 10⁻¹⁰
add the coefficients[tex]\tt =(3.5+700)\times 10^{-10}\\\\=703.5\times 10^{-10}\\\\=7.035\times 10^{-8}[/tex]
Answer:
in other words its: d
Explanation:
1. Shankar and Sameer performed an experiment to differentiate primary, secondary and tertiary amines in a laboratory.Shankar correctly identified those 3 compounds but Sameer could only identify primary amine. a) What may be the reagent used by Sameer 1) Ammonical Silvernitrate solution 2) Chloroform & Caustic potash 3) Aqueous Copper Sulphate solution
Answer: 2) Chloroform & Caustic potash
Explanation:
The carbylamine reaction is a kind of chemical test which is done to detect primary amines in an unknown solution. It cannot detect secondary and tertiary amines.
The reaction involves the heating with up of the unknown solution with alcoholic potassium hydroxide or caustic potash and the chloroform.
In the presence of primary amine, the production of isocyanide results.
HELP ASAP
1. a hurricane destroyed an entire city, what category would it most likely be?
a Category 4 or 5
b Category X or Y
c Category 1 or 2
d Category A or B
2. What happens immediately after a hurricane makes landfall?
a It starts hailing.
b Its winds pick up speed.
c It gets stronger.
d It gets weaker.
Answer:
1. category 4 or 5
2. it gets weaker
What is the force of attraction between two atoms that are combined?
a. chemical bond
b. atomic bond
c. physical property
d. magnetic bond
Answer:
a
Explanation
Chemical bond refers to the forces holding atoms together to form molecules and solids. This force is of an electric nature, and the attraction between electrons of one atom to the nucleus of another atom contributes to what is known as chemical bonds.
What is the mass of hydrogen produced when 8.0 g of sodium
reacts with an excess of water to produce hydrogen and sodium
hydroxide? The equation is given.
2 Na + 2 H2O → 2NaOH + H2
Answer:
Mass = 0.35 g
Explanation:
Given data:
Mass of sodium = 8.0 g
Mass of hydrogen produced = ?
Solution:
Chemical equation:
2Na + 2H₂O → 2NaOH + H₂
Number of moles of sodium:
Number of moles = mass/molar mass
Number of moles = 8.0 g/ 23 g/mol
Number of moles = 0.35 mol
now we will compare the moles of sodium and hydrogen
Na : H₂
2 : 1
0.35 : 1/2×0.35 = 0.175 mol
Mass of hydrogen:
Mass = number of moles × molar mass
Mass = 0.175 mol × 2 g/mol
Mass = 0.35 g
If you have 6.02x10^23 molecules of trisulfur monoxide, how many grams would it weigh?
Answer:
112.18 g.
Explanation:
you're using stoichiometry to find the mass of the compound S₃O.
CH(4)+ 20(2)→ CO2+ 2H(2)O
22.
The reaction shown above is an example of a -
a. synthesis reaction
b. combustion reaction
c. decomposition reaction
d. double displacement reaction
Answer:
Reaction is a Combustion reaction
What is the molecule that formed between B and F?
Answer:
Hydrogen bond strengths range from 4 kJ to 50 kJ per mole of hydrogen bonds. In molecules containing N-H, O-H or F-H bonds, the large difference in electronegativity between the H atom and the N, O or F atom leads to a highly polar covalent bond (i.e., a bond dipole).
Explanation:
someone help me plz :))) brainliest
Answer:
Option 2
Explanation:
I’ll marmark you brainlist
Careless work, fraud, biases, confirmation bias, are all examples of ________________.
Question 10 options:
poor science
good science
higher level science
popular science
Answer:
Poor Science
Explanation:
I took the quiz also just think that doesn't seem like a good, higher level scientist, or popular one, SO THERE YOU GUYS GO!!!
Answer:
poor science
Explanation:
A recipe calls for 0.8 oz of cheese. If I make 35 batches of this recipe, how many ounces of cheese do I need?
b. How do metals and non-metals differ chemically?
1
how do you separate immiscible and miscible liquid
Answer:
A mixture of immiscible liquids is separated by using an apparatus called separating funnel. (i) Separation by fractional distillation : Fractional distillation is the process of separating two (or more) miscible liquids by distillation, the distillate being collected in fractions boiling at different temperatures.
Explanation:
hope this sorta helps you -.-
What did you include in your response? Check all that
apply.
O No, thermal energy is not being transferred by
radiation in this image.
O The eggs are in direct contact with the metal pan,
which is in direct contact with the gas flame.
O Thermal energy is being transferred by conduction.
O Radiation transfers thermal energy by
electromagnetic waves.
O Radiation does not transfer thermal energy by
direct contact.
3. Which of the following is an example of a polyatomic ion?
a. NO
b. OP-
C. CI
d. Ca²+
Answer:D
Explanation:polyatomic means more then one and it have more then 1 positive ion
PLZ FASTLEY ANSWER The images show two metamorphic rock samples.
Left: light colored rock with coarse texture. Right: red and white rock with rounded grains and coarse texture.
Which statement accurately describes these rocks?
Both rocks are non-foliated.
Neither rock has randomly arranged grains.
Both rocks formed at Earth’s surface.
Neither rock formed through extreme heat or pressure.
Answer:
a
Explanation:
From the given images, it is clear that both rocks are non-foliated rocks because they don't have distinct repetitive layers. Hence option a is correct.
What are metamorphic rocks?Metamorphic rocks are formed through intense pressure and heating from the sedimentary or igneous rocks. Sometime the change n heat or pressure make the metamorphic rocks gets foliated.
Foliation occurs when pressure forces flat or elongate minerals within a rock to align. These rocks form a platy or sheet-like structure that reflects the pressure direction. There is no platy or sheet-like structure in non-foliated metamorphic rocks.
Non-foliated rocks can be created in a variety of ways. Some rocks, like limestone, are composed of minerals that are not flat or elongate. Therefore, the given rocks are non-foliated.
To find more on foliated rocks, refer here:
https://brainly.com/question/1984747
#SPJ2
what's the molar mass of Li3p
Answer:
51.79g Li₃P.
Explanation:
Li has a molar mass of 6.94 g (since there are 3, you multiply it 3 times) and P has a molar mass of 30.97 g. 6.94(3) + 30.97 = 51.79g.
Which of the following would increase the intensity of the tornado?
a. decrease in wind speed
b. decrease in condensation
c. increased rate of evaporation
d. increase of cold air
In which material would the particles be closest together?
O Syrup
O Brick
O Air
O Water
Answer:
Brick
Explanation:
The distance between particles is best determined by density. So, to find which material has the most compacted particles, we need to find which material has the highest density. Solids will always have the highest densities, so Brick would have the particles that are closest together.
(oh no)
What is the mass of silicon when there are 1.8 x 10^21 atoms of silicon?
Answer:
Mass = 0.084 g
Explanation:
Given data:
Mass of silicon = ?
Number of atoms of silicon = 1.8 × 10²¹ atom
Solution:
Avogadro number:
The given problem will solve by using Avogadro number.
It is the number of atoms , ions and molecules in one gram atom of element, one gram molecules of compound and one gram ions of a substance. The number 6.022 × 10²³ is called Avogadro number.
1 mole = 6.022 × 10²³ atoms
1.8 × 10²¹ atom × 1 mole / 6.022 × 10²³ atoms
0.299× 10⁻² mol
0.00299 mol
Mass of silicon:
Mass = number of moles × molar mass
Mass = 0.00299 mol × 28.1 g/mol
Mass = 0.084 g
What is the relationship between Force and Velocity?
Affect/Effect
Cause/Blame
Claim/Reasoning
Cause/Effect
Answer:
Cause/ effect relationship.
Explanation:
because the force is the cause of energy that is present and velocity is the effect (speed) that is present.
Airplanes typically fly at an altitude of about 10,000 meters. At this altitude the atmospheric pressure is significantly less than it is at sea-level. Because of this, airplane cabins must be pressurized so that the people on board can continue to get enough oxygen. If a typical 747 has a volume of 28,000 m3 and is filled with air at 101.3 kPa on the ground, what is the new volume of air inside when the cabin is pressurized to 75 kPa once it is in flight?
Answer:
37,818.67 m3
Explanation:
The pressure a gas will exert on a container is inversely proportional to the volume of the gas. According to Boyle's law, at a constant temperature, the pressure of a gas is inversely proportional to its volume. The law can be mathematically represented thus:
P1V1 = P2V2
In this case, P1 = 101.3 kPa, V1 = 28,000 m3, P2 = 75 kPa, V2 = ?
V2 = P1V1/P2
= 101.3 x 28,000/75
= 37,818.67 m3
Hence, the new volume of the air inside the cabin after pressurizing would be 37,818.67 m3.
When using a light microscope, focus the specimen with the scanning objective
lens first.
Reasoning:
Answer:
The light microscope bends a beam of light at the specimen using a series of lenses to provide a clear image of the specimen to the observer.
fountain
21. Calculate the quantity of electricity
in coulombs used when a current of
2.7 ampere is passed through a
solution of silver salt for 25 minutes
20 seconds
A. 87.5
B. 206
C. 1350
D. 4050
E. 4104
Answer:
4104 Coulombs
Explanation:
charge = time(sec) *current
25*60 =1500+20=1520
2.7A * 1520 sec =4104
4104 C
10.0 grams of a gas occupies 12.5 liters at a pressure of 42.0 mm Hg. What is the volume when the pressure has increased to 75.0 mm Hg? 6.72 L 7.00 L 22.3 L 0.143 L
Answer: 7.00 L
Explanation:
Boyle's Law: This law states that pressure is inversely proportional to the volume of the gas at constant temperature and number of moles.
[tex]P\propto \frac{1}{V}[/tex] (At constant temperature and number of moles)
[tex]P_1V_1=P_2V_2[/tex]
where,
[tex]P_1[/tex] = initial pressure of gas = 42.0 mm Hg
[tex]P_2[/tex] = final pressure of gas = 75.0 mm Hg
[tex]V_1[/tex] = initial volume of gas = 12.5 L
[tex]V_2[/tex] = final volume of gas = ?
[tex]42.0\times 12.5=75.0\times V_2[/tex]
[tex]V_2=7.00L[/tex]
Therefore, the volume when the pressure has increased to 75.0 mm Hg is 7.00 L
what happens when thermal energy is added to a substance?
Answer:
Explanation:
I believe that particles would move more faster and more thank likely increase kinetic energy when thermal energy is added to something.
The PC modem was invented in what year?
Answer:
1977
Explanation:
Getting connected: a history of modems. Then, in 1977, Dale Heatherington and Dennis Hayes created the world's first PC modem, the 80-103A.
What is mass movement give examples
How do the particies in a liquid create surface
tension?
It's been a while since I've taken Chemistry but here's what I know:
There are small, weak bonds that form between water molecules. These bonds make it so liquid molecules (water, in this example) cannot move as freely as a gas, but their bonds aren't nearly as strong as a solid. The bonds are formed when a hydrogen atom is attracted to an oxygen atom (because they have an opposite charge). This bond plus the gas molecules hitting the water causes surface tension.
(Let me know if this is wrong and I hope you have a lovely day!!)
What is the unit for the answer?
23.67 boops
x
0.256 snoots
35 boops
Х
520. zoinks
Х
92 snoots
2
218 snoots
34 wout
Х
2
8765 wows
345 zoinks
boops
snoots
WOWS
zoinks
wows/snoots
boops/zoinks
Answer:Answer to: A function f is defined on the interval ~[0,4], and its derivative is { e^{sinx} - 2cos3x } a. on what interval is f increasing? b....
Missing
Explanation: