Which statement about
destructive interference is true?

The atomic mass unit is equivalent to 1 of the mass of a neutral atom of carbon.

It is defined as one out of twelve parts of the mass of the neutral atom of the most abundant isotope of carbon, that is, carbon 12.

By this definition, it is obvious that the atomic mass unit of elements is measured with respect to the mass of a neutral atom of carbon 12 - not hydrogen, gold, or oxygen.

More on the atomic mass unit can be found here: https://brainly.com/question/489186

Answer:

Explanation:

i think it is the last one. hope it is correct

Answer:

It would start at 0 and keep graduatly growing bigger and bigger numbers

Explanation:

Answer:

The element that is likely to be present is LITHIUM.

Explanation:  ABOUT FLAME TEST

An analytical chemistry method used to help identify metal ions is the flame test. It can not be used to classify all metals, although it is a useful qualitative research test and a lot of fun to perform, since not all metal ions emit flame colors. Some metal ions also display colors similar to each other, making it difficult to tell them apart. However, for the detection of various metals and metalloids, the test is still useful.

One downside of the flame test is that the light color that is detected depends very much on the flame's chemical composition (the fuel that is being burned). This makes it difficult to match colors with a chart that has a high level of trust.

The bead test or blister test, in which a bead of salt is coated with the sample and then heated with a Bunsen burner flame, is an alternative to the flame test. Because more samples stick to the bead than to a simple wire loop, this test is slightly more accurate and Since most Bunsen burners, which appear to burn with a clean, blue flame, are linked to natural gas.

      ABOUT LITHIUM ELELMENT -:It's metal, but it's soft enough to cut with a knife .It is so light that water can float on it.   It is hard to put out lithium fires.   Lithium, along with hydrogen and helium, was one of the three elements that the Big Bang produced in vast amounts.

Hence , we identifies the element in flame test by the color produces that is magenta or pink-red which gives the element Lithium . Therefore , the correct answer is lithium.

Answer:

In flame of pure hydrogen burning in air, the hydrogen (H2) reacts with oxygen (O2) to form water (H2O) with the release of energy. In atmospheric air rather than pure oxygen, hydrogen combustion may yield a small amount of nitrogen oxides with the water vapor. The energy released allows hydrogen to be used as a fuel.

Explanation:

Here are the steps that occur during the combustion of hydrogen; Initiation, Propagation, Completion, and Energy Release.

The combustion of hydrogen involves a chemical reaction with oxygen in the air, resulting in the release of energy in the form of heat and light.

Initiation: The combustion process begins by supplying energy to break the initial bonds in the reactant molecules. In the case of hydrogen combustion, heat or an external ignition source is provided to break the diatomic hydrogen molecules (H₂) into individual hydrogen atoms (H).

H₂ → 2H

Propagation: Once the hydrogen molecules are dissociated into hydrogen atoms, they react with oxygen (O₂) molecules from the air. This reaction occurs in a chain reaction mechanism involving three steps: initiation, propagation, and termination.

Initiation: Hydrogen atoms react with oxygen molecules to form hydrogen peroxide (H₂O₂) and hydroxyl radicals (OH).

H + O₂ → HO₂

H + HO₂ → H₂O₂

Propagation: The hydroxyl radical (OH) reacts with hydrogen molecules to form water vapor (H₂O) and release heat.

OH + H₂ → H₂0 + H

Termination: The chain reaction terminates when two radicals combine to form stable products.

H + OH → H₂0

Completion: The chain reaction continues as long as there is a sufficient supply of hydrogen and oxygen. The hydrogen atoms released in the propagation step can initiate further reactions with more oxygen molecules, leading to the complete combustion of hydrogen to form water vapor (H₂O).

H₂ + O₂ → H₂O

Energy Release: The combustion of hydrogen is an exothermic reaction, which means it releases energy in the form of heat and light. This energy is responsible for the heat and light produced by a burning hydrogen flame.

To know more about combustion here

https://brainly.com/question/34266172

#SPJ3

Answer:

Typical sizes of atom and nucleus.

Most of atom's mass is in the nucleus.

Constituents: protons, neutrons, electrons.

Electric force holds atom together.

Explanation:

Answer:

I think it's C.copper conducts heat

The elements of the periodic table are arranged in the families and periods based on their properties. Copper (Cu) is a transition metal that can conduct electricity. Thus, option C is correct.

Transition metals are the metallic elements that are arranged in groups 3 - 12 and periods 4-7. They are also called d-block elements due to the electron present in the d orbit of the atom making them capable of bond formation.

They all show the properties of metals that include shininess, luster, conductivity, etc. The series include copper, iron, cobalt, gold, zinc, chromium, nickel, manganese, molybdenum, etc.

Copper being a transition metal has the property of conducting electricity and is used in wirings as they have loosely bounded electrons in their shell that can carry the electrical charge in a circuit.

Therefore, option C. copper (Cu) can conduct electricity and heat is correct.

Learn more about transition metals here:

https://brainly.com/question/15723396

#SPJ5

Photosynthesis is that plant process is affected most during this darkness because photosynthesis only occurs when there is sunlight.

Photosynthesis is a process in which water and carbondioxide combine in the presence of sunlight and produce glucose and oxygen. We know that Photosynthesis occurs only at daytime.

So we can conclude that Photosynthesis is affected during this darkness because photosynthesis only occurs when there is sunlight.

Learn more about tilt here: https://brainly.com/question/8678564

Using accurate measurements, using pure chemicals and performing the reaction under the most ideal conditions is important to get a valuable percent yield.

Percent yield of any chemical reaction is define as the ratios of the actual yield to the theoretical yield of the product and multiply by the 100.

To get the high percent yield or actual yield of any reaction, we have to perform the reaction under ideal condition because if we not use the standard condition then we get the low rate of reaction. Reactants should be present in the pure form as impurity make unwanted products and reduce the productivity of main product and accurate amount of reactants also important for the spontaneous reaction.

Hence, options (a), (b) & (c) are correct.

To know more about percent yield, visit the below link:

https://brainly.com/question/8638404

Answer:

Answer: According to 2019 figures from the US Department of Energy, the average commercial tidal energy project costs as much as $280 per megawatt hour. Wind energy, by comparison, currently costs roughly $20 per megawatt hour and is "one of the lowest-priced energy sources available today," according to the agency.

Explanation:

Answer:

The two cost of using tides for energy is solor and wind.

Answer:

milk liquid

helium gas

granite solid

oxygen gas

steel solid

gasoline liquid

Answer: Milk is liquid. Helium is gas. Granite is solid. Oxygen is gas. Steel is solid. Gasoline is liquid.

Explanation:

Answer: B. the United States and the Soviet Union

Explanation:

Water is called the universal solvent

Please mark as brainliest

Answer:

all u need to do is this 27 + 30 = 57.

Explanation:

Answer:

CH3COOH

Explanation:

CH3COOH has the highest boiling point because it participates in the strongest intermolecular interactions. The -OH group can participate in hydrogen bonding with other -OH groups. Hydrogen bonds are very strong because they are the result of large partial positive charge on the hydrogen and large partial negative charge on the oxygen. When surrounded by other -OH groups, the partial positive charge on the hydrogen can form temporary bonds with the partial negative charge of an oxygen on another molecule. The stronger the intermolecular interactions, the more difficult they are to overcome, thus increasing the boiling point.

The strongest IMF the other molecules participate in are dipole-dipole. These interactions are not as strong as hydrogen bonding.

The car travels 50 miles per hour. To find the distance it travelled in 3 hours, multiple 50 by 3.

50 x 3 = 150

Therefore, the car would travel 150 miles in 3 hours.

Answer:D.

Explanation:

[tex]mass = number \: of \: moles \times molar \: mass[/tex]

[tex]m = 2.36(223.2) = 526.752 \: grams[/tex]

[tex]n = \frac{mass}{molar \: mass} = \frac{23.5}{58.4} = 0.40239 \: moles[/tex]

[tex]n = \frac{0.778}{49} = 0.0158775 \: moles[/tex]

[tex]n = \frac{number \: of \: particles}{avogadros \: constant} [/tex]

[tex]n \: o \: p = 0.0455 \times 6.02 \times 10 {}^{23} = 2.7391 \times 10 {}^{22} particles[/tex]

Mass in grams of 2.360 moles of lead (II) oxide is 0.0105.

Avogadro's number is the number of units in one mole of any substance and equals to 6.02214076 × 10²³. The units can be electrons, atoms, ions, or molecules.

No. of moles is defined as a particular no. of particles that we can calculate with the help of Avogadro’s number.

Mass of a particular product is also find out by stoichiometry of a reaction as per the no. of mole given in the reaction.

Given, No. of moles of lead oxide = 2.360 grams

No. of moles = Mass of compound ÷ Molar mass of compound

No. of moles = 2.36 ÷ 223.2

No. of moles = 0.0105

Therefore, Mass in grams of 2.360 moles of lead (II) oxide is 0.0105.

Learn more about mole concept, here:

https://brainly.com/question/31123980

#SPJ2

Answer:

H20

Explanation:

Answer:

Question stealer :]]

Explanation:

Answer:

things that pollute the air

Explanation:

nuclear energy, fossil fuels, gas from cars and other transportation, and these all contribute to greenhouse gases that are harmful to the environment

hope this helped!

Invalid equation.

..............

Answer : Geela away is [tex]33.22\times 10^{15}\text{ miles}[/tex]

Explanation :

As we are given that the alien tells you that it has traveled here from the planet Geela which is 5.670 × 10³ light years away.

And we know that:

[tex]1.06\times 10^{-16}\text{ light years}=6.21\times 10^{-4}\text{ miles}[/tex]

Now we have to determine the distance away is Geela.

As, [tex]1.06\times 10^{-16}\text{ light years}=6.21\times 10^{-4}\text{ miles}[/tex]

So, [tex]5.670\times 10^{3}\text{ light years}=\frac{5.670\times 10^{3}\text{ light years}}{1.06\times 10^{-16}\text{ light years}}\times 6.21\times 10^{-4}\text{ miles}[/tex]

                                      = [tex]33.22\times 10^{15}\text{ miles}[/tex]

Therefore, the Geela away is [tex]33.22\times 10^{15}\text{ miles}[/tex]

Answer:

This is an example of a form of energy transferring itself. Tons of electrons are passed through the energy itself to you very quickly. That's why when we touch a hot surface and get burned, it's because our skin molecules are touching the heat molecules.

Answer:

1.35moles

Explanation:

mm=18.02gmol⁻¹   mass=24.3g

mole=mass/mm

mole=24.3/18.02

mole=1.35moles

Answer:

Explanation:

To find the number of moles given the molecular weight and mass we use the formula

[tex]n = \frac{M}{m} \\ [/tex]

where

n is the number of moles

M is the molar mass

m is the mass of the substance

From the question

m = 24.3 g

M = 18.02 g/mol

We have

[tex]n = \frac{24.3}{18.02} \\ = 1.348501664...[/tex]

We have the final answer as

Hope this helps you

Answer:

4

Explanation:

Answer to balance the equation

P4 + 6Cl2 => 4PCl3

Answer:

C

Explanation:

Answer:

1. The three parts of an atom are:

2. A neutron is a particle of an atom with a neutral charge.

Hope this helps!

Answer:

A direct relationship

Explanation:

The graph shows a direct relationship due to the fact that the line is going up in a positive correlation/increasing as the amount of mass and volume increase.

Answer:

T

F

T

Explanation:

hope it helps! sorry for no explanation

Answer:

second one/ B

Explanation:

just took the quiz

Answer:b

Explanation: