An automobile with a mass of 1250 kg accelerates at a rate of 4 m/sec2 in the forward direction. What is the net force acting on the automobile?​

Answer:

The force of gravity on earth, no matter the object is approximately 9.8 m/ s2 . The reason the crumpled paper hits the ground first is because of air resistance. A crumpled piece of paper has less surface area than an piece of paper that is not crumpled. More surface area means more air resistance.

Answer:

1.) TABLE = The table is 2.74 m (9.0 ft) long, 1.525 m (5.0 ft) wide, and 76 cm (2.5 ft) high with any continuous material so long as the table yields a uniform bounce of about 23 cm (9.1 in) when a standard ball is dropped onto it from a height of 30 cm (11.8 in), or about 77%.

2.) TENNIS = Tennis is a racket sport that can be played individually against a single opponent (singles) or between two teams of two players each (doubles). Each player uses a tennis racket that is strung with cord to strike a hollow rubber ball covered with felt over or around a net and into the opponent's court.

3.) PING-PONG = Table tennis, also known as ping-pong and whiff-whaff, is a sport in which two or four players hit a lightweight ball, also known as the ping-pong ball, back and forth across a table using small rackets. ... Spinning the ball alters its trajectory and limits an opponent's options, giving the hitter a great advantage.

4.) NET = This is stretched across the centter of the table by a cord attached to a post at either end. It measures 6ft long and the ball must pass over it for a rally to continue.

5.) BALL = The ball, which is spherical and hollow, was once made of white celluloid. Since 1969 a plastic similar to celluloid has been used. The ball, which may be coloured white, yellow, or orange, weighs about 0.09 ounce (2.7 grams) and has a diameter of about 1.6 inches (4 cm).

6.) RACKET = A table tennis racket is made up of two distinct parts - a wooden blade which incorporates the handle together with table tennis rubbers affixed to each side of the blade using water-based glue.

Explanation:

All my answers are

about the tools of the

game of tennis

This is because the cloth soaked in water can absorb and evaporate the heat from your forehead.

This technique is used to cool down your fever, and to help you feel better.

Answer:

density can be written as:

d = F / V  (weight density) or M / V (mass density)

Since F in the first equation can be written as

B = d V where B is the buoyant force and is proportional to the

weight of the liquid displaced

For a given volume the weight of the liquid displaced is proportional to the density and hence the buoyant force

Answer:

We can determine the age of the Earth and the rocks found on Earth with techniques such as measuring ice cores and digging and analysing fossils.

Explanation:

Hopefully this helped!

Answer:

Astronomers think there are between 1.1 and 1.9 million asteroids in the solar system.

Explanation:

Answer:

The gravity helps the planets stay together near the Sun, without it Earth would be floating away with the planet eventually becoming frozen up, thus the role gravity have in the motion of planets around the sun is by keeping them together.

Explanation:

Hope this helps!

Answer:

180 [J].

Explanation:

1) the required work [W] can be calculated as difference of the energy: W=E₂-E₁, where E₁=mgh₁ - the energy before lifting, E₂=mgh₂ - the energy after lifting;

2) W=mgh₂-mgh₁, where m - mass; g=10 [N/kg], h - height;

3) then the required work [W]:

W=mg*(h₂-h₁)=30*6=180 [J].

Answer:

Friction

Explanation:

As the skateboarder goes down the ramp, potential energy is converted to kinetic energy. Because of friction, some of the energy in the system is converted to heat energy. Once the kinetic energy is converted to heat, the energy cannot be converted back to the potential or kinetic energy in the system.

Answer:

1) A 1L bottle, with a height of 30cm, full of water is emptied. The bottle is filled with oil (density = 920 kg/m^3). Calculate the change in pressure of the bottom of the first bottle. If you decide to put potatoes (assume its density is  1,8 kg/m^3), each one of a volume V = 10 cm^3, will they float?

2) The fusion temperature of the Nitrogen is -210°C and its boiling temperature is 77K. Calculate the difference between the fusion temperature and the boiling temperature.

This question involves the concepts of the law of conservation of energy and kinetic energy.

The variables required for a computational model that predicts change in the energy of a falling object are "B.)Height, speed, mass".

According to the law of conservation of energy the change in energy can be given in the following form for a falling object:

Loss in Potential Energy = Gain in Kinetic Energy

[tex]mgh = \frac{1}{2}mv^2[/tex]

It is clear from the formula that the variables involved in the computational model are mass, height, and velocity.

Learn more about the law of conservation of energy hee:

brainly.com/question/381281?referrer=searchResults

Answer:

b) height, speed, mass

Explanation:

just took the test

Answer:

- 30 kW

Explanation:

IDEA:

Power of an object that does work(source) is given by:

[tex] \boxed{ \mathsf{power = \frac{work \: done}{time} }}[/tex]

where work done is mostly shown as the Force applied on an object to Displace it through some distance in the same direction as the Force.

[tex] \boxed{ \mathsf{ work = force \times displacement}}[/tex]

___________________

INFORMATION:

In the question,

The source of power is the crane, while the object is a load of 36000N.

Note, what's given is the force, not the mass. Since, the SI unit of mass is kg and that of Force is Newton(N).

[The weight of the load is represented in Newton, since weight of an object is the amount of Force with which the Earth attracts that object]

I) work done

So,

=> Work = 36000 × 50

= 1,800,000 J

(The SI unit of work is Joules(J)).

___________________

II) power

After getting the amount of work done, now we have to place it in the formula for power.

That is:

[tex] \boxed{ \mathsf{power = \frac{work \: done}{time} }}[/tex]

Note, During calculations, all quantities must be in their SI units.

SI unit for time is Seconds (s)

But the time we have is in minutes.

___________________

Converting time from minutes to Seconds:

1 minute = 60 Seconds.

Hence,

[tex] \implies \mathsf{power = \frac{1800000}{60} } \: [/tex]

=> power = 30,000 W

(SI unit of power is Watts(W))

To write four zeroes with a 3 and W is a lot of effort. So, we can look for simple expressions like kilowatts(kW) that can express bigger quantities in lesser terms.

1000 W = 1 kW

___________________

Direction and sign:

The crane displaces the load in an upward direction (from the term "lifts")

But, the Force is acting downwards, as the weight of the body is always towards the Earth.

Since, the directions of Force and displacement are opposite, a minus takes its place in front of both Work and power.

___________________

Therefore, the final answer will be:

To make the boiler more efficient, we would replace the resistor with another double the length.

We know that the resistance of the resistor in the boiler is given by R = ρl/A where

Also, the power generated by the resistor is P = i²R where

If i is constant, we see that P ∝ R.

So, to increase the efficiency, the value of the resistance has to increase.

Also, since R = ρl/A and ρ and A are constant, we see that R ∝ l.

Since P ∝ R and R ∝ l ⇒ P ∝ l.

So, to increase the efficiency, we would double the length of the resistor.

So, to make the boiler more efficient, we would replace the resistor with another double the length.

Learn more about resistors here:

https://brainly.com/question/25209910

Answer:

100

Explanation:

By adding an external resistor of  287.5 Ω in series with the meter, the conversion of the moving coil meter to have a full-scale deflection for a current of 50 mA.

Current sensitivity (S) is the ratio of full-scale deflection current to full-scale deflection voltage.

S = I(fsd) / V(fsd).

S = 4.0 / 25

S = 0.16 mA/Ω

Desired current sensitivity for 50 mA (S(new)) = 50 mA / V(fsd)

(S(new)) = 50 mA / V(fsd)

(S(new)) =  50  / 0.16

(S(new)) =  312.5 Ω

Add External Resistor:

Add an external resistor (R(ext)) in series with the meter. Calculate R(ext) as the difference between R(new) and the internal resistance of the meter

(R(internal) = 25 Ω:

R(ext) = R(new) - R(internal)

R(ext) = 312.5 Ω - 25 Ω

R(ext) = 287.5 Ω

By adding an external resistor of  287.5 Ω in series with the meter, the conversion of the moving coil meter to have a full-scale deflection for a current of 50 mA. This will achieve the desired result.

To know more about the external resistor:

https://brainly.com/question/32843695

#SPJ3

Answer:

C)

Explanation: In freefall motion object always has gravity as its acceleration.

Answer:

B.

Explanation:

Density = mass / volume

= 0.01/0.05

= 0.2 kg/m^3.

Answer:

Iron, cobalt, and nickel are the only three naturally occurring elements that are magnetic. 

Explanation:

hope it helps

correct me if I'm wrong thank you

brainliest please

Answer:

The three elements that can be used to make a magnet are :

Aluminum, nickel and cobalt

Hi there!

We can begin by solving for the velocity in which the ball was thrown at using the following:

[tex]v_f^2 = v_i^2 + 2ad[/tex]

At the top of the trajectory, the ball's velocity is equal to 0 m/s, so:

[tex]0 = v_i^2 + 2ad\\\\vi^2 = 2ad \\\\[/tex]

'a' = acceleration due to gravity and 'd' is the max height, so:

[tex]v_i^2 = 2(10)(5)\\\\v_i^2 = 10 m/s[/tex]

Now, we can use the same equation to calculate the final speed at 4.5 m. Remember, the acceleration is NEGATIVE in this instance (taking the negative direction to be in the direction of gravity).

[tex]v_f^2 = 10^2 - 2(10)(4.5)[/tex]

[tex]v_f^2 = 10^2 - 2(10)(4.5)\\\\v_f^2 = 100 - 90 \\\\v_f^2 = 10 \\\\v_f = \boxed{3.1 m/s}[/tex]

Explanation:

[tex] \rule{999pt}{66646pt}[/tex]

Answer:

I just put a random number for the work

Explanation:

I hope it is ok.

Answer:

I think it would be 0.1496 but I'm not really sure sorry

Explanation:

Ummm i think a timer or clock?

Answer: Timer or a clock

Explanation:

The driver is telling the truth, the radar gun must have been set incorrectly to record relative velocity.

The given parameters:

The speed limit of the driver in meter per second is calculated as follows;

[tex]= 60 \ \times \frac{miles}{hour} \times \frac{1609.34 \ m}{1 \ mile} \times \frac{1 \ hr}{3600 \ s}\\\\= 26.82 \ m/s[/tex]

From the speed limit, it is obvious that the driver's speed is within the limit. Thus, we can conclude that the driver is telling the truth, the radar gun must have been set incorrectly to record relative velocity.

Learn more about relative velocity here: https://brainly.com/question/17228388

[tex]\\ \sf\Rrightarrow V=\dfrac{W}{Q}[/tex]

[tex]\\ \sf\Rrightarrow V=\dfrac{9}{1}[/tex]

[tex]\\ \sf\Rrightarrow V=9V[/tex]

The acceleration of the first block (4 kg) is -9.8 m/s².

The given parameters:

The net force on the system of the two blocks is calculated as follows;

[tex]m_2 g - T = m_1 a[/tex]

where;

[tex]m_2 g - m_1 g = m_1 a\\\\a = \frac{m_2 g - m_1g}{m_1} \\\\a = \frac{g(m_2 - m_1)}{m_1} \\\\a = \frac{9.8(2-4)}{2} \\\\a = -9.8 \ m/s^2[/tex]

Thus, the acceleration of the first block (4 kg) is -9.8 m/s².

Learn more about net force on two connected blocks here: https://brainly.com/question/13539944