Answer:
Explanation:
The Kinetic Energy (K.E) of an object can be calculated as:
We are given:
K.E = 480 K
Velocity of the object = v = 8 m/s
Using the values, we get:
Thus, the mass of the object will be 15 kg.
The mass of the object at the given momentum and speed is determined as 5 kg.
Momentum of the object
The momentum of the object is calculated as follows;
P = mv
where;
m is mass of the objectv is speed of the objectm = P/v
m = 40/8
m = 5 kg
Thus, the mass of the object at the given momentum and speed is determined as 5 kg.
Learn more about momentum here: https://brainly.com/question/7538238
#SPJ2
is p2 polar or no polar
Answer:
Non-polar
Explanation:
The way to determine if something is polar is by subtracting their electronegativity values. The two atoms in this molecule are both phosphorous which have equal electronegativity values (since they are both phosphorus). Anything minus itself will equal 0. If the final difference between the electronegativity values is less than 0.4, it will be non-polar. Since the result is 0, P2 is non-polar.
In P₂ molecule there is absence of partial charges, thus the molecule has been nonpolar.
The molecules have been differentiated based on polarity as polar and nonpolar molecules. The molecules that have been comprised of the difference in the electronegativity of the elements and develop partial charges have been termed polar compounds.
The compounds with no difference in electronegativity and absence of partial charges are termed nonpolar molecules. In the P₂ molecule, there have 2 phosphorus molecules with the same electronegativities.
Since there has been an absence of polarity in the molecule, the molecule of P₂ is nonpolar.
For more information about polar molecules, refer to the link:
https://brainly.com/question/24775418
Question 2
5 pts
(03.01 MC)
The nucleus of an atom is dense and positively charged. What was observed when
positively charged particles were radiated onto a gold atom during Rutherford's
experiment because of this?
O Negative charges were concentrated at the center of the atom.
N
Particles that struck the center of the atom were repelled.
Particles that struck the edges of the atom were repelled.
Positive charges were distributed all over the atom.
Answer:
The correct answer is particles that struck the center of the atom were repelled.
Explanation:
Rutherford performed an experiment which is called the gold foil experiment. In the gold foil experiment of the Rutherford, a gold foil is bombarded with the positively charged alpha particles. The bombardment of the alpha particles shows the unexpected result to Rutherford.
He thought these particles go through the gold foil but to his surprise, some particles bounced back and some deflected after colliding with foil. On the basis of these, he suggested that there is a positive charge present in the center of an atom that repelled the positive charge of alpha particles and leads to deflection and bouncing back.
Thus, the correct answer is particles that struck the center of the atom were repelled.
NEED ASAP!!
Which statement describes a chemical property of a mineral?
A. The mineral forms gas bubbles when a sample is stored in water.
B. The mineral's surface is easily scratched by other materials.
C. The mineral's color can be white, pink, or yellow.
D. The mineral's luster is dull, even if you polish it.
Answer:
B
Explanation:
sorry I have to write here
Answer:
a
Explanation:
i got it right
What do electric conducts and thermal conducts have in comman?
Usually electrical conductors have loosely bound electrons. Materials that conduct heat are thermal conductors
what is the wavelength of a red laser with a frequency of 4.3 x 10^54 Hz
Answer:
The wavelength is 7.0x10⁻⁴⁷ m
Explanation:
To solve this problem we can use the equation:
c = λ*vWhere:
c is the speed of light (3x10⁸m/s)λ is the wavelenght (in m)v is the frequency (in Hz)We put the data given by the problem:
3x10⁸ m/s = λ * 4.3x10⁵⁴ HzAnd solve for λ:
λ = 7.0x10⁻⁴⁷ mWhat is a transform boundary, and how does it affect the land?
Answer:
simple
Explanation:
A transform fault or transform boundary is a fault along a plate boundary where the motion is predominantly horizontal.[1] It ends abruptly where it connects to another plate boundary, either another transform, a spreading ridge, or a subduction zone.[2]
Which of the following is NOT needed for photosynthesis to take place?
A. glucose
B. chlorophyll
C. water
D. light energy
find the pOH of a solution made by dissolving 10.4g of HCl in a 500mL solution of water
The pOH of a solution : 13.756
Further explanationMass HCl=10.4 g
mol HCl (MW=36.5 g/mol) :
[tex]\tt mol=\dfrac{mass}{MW}=\dfrac{10.4}{36.5}=0.285[/tex]
Volume of HCl = 500 ml = 0.5 L
[tex]\tt M=\dfrac{n}{V}\\\\M=\dfrac{0.285}{0.5}=0.57~M[/tex]
HCl ⇒ H⁺ + Cl⁻
[H⁺]=[HCl]=0.57 M
pH= - log[H⁺]
pH=-log[0.57]=0.244
pH+pOH=14
pOH=14-0.244
pOH=13.756
PLEASE ANSWER I WILL GIVE YOU BRAINLY ASAP PLEASE ANSWER THANKYOU!!!!!!!!!!!!!!!!!!!!!!!!! ITS FOR MY FRIEND SO PLEASE ANSWER!!!!!
Using the diagram below and the labels attached to it answer the following:
Transverse Wave Anatomy
1. Define the crest and trough of a wave and identify TWO points that represents a crest or a trough.
2. Define wavelength and identify TWO points that could be used in the diagram to measure it.
2. Determine the frequency of this wave if the waves the diagram represents occurred within 1 second.
Answer & Explanation:
Crest is a point in the cycle where maximum or peak amplitude exists. In another way, it is a point on the positive side of a wave where maximum amplitude exits. Trough is a point in the cycle where minimum amplitude exists.
Crest: points A and E
Trough: points C and J
Wavelength is the distance between two crests or two troughs. One example is distance between points A and E.
Frequency is 3 because there are 3 oscillations in 1 second (follow the line from beginning to point D, then D to G, the G to end).
please give thanks by clicking heart button :)
and brainliest if it is an option
pleaseeee help me solve this answer
Answer:
A open system
I think plz tell me if i'm wrong
Explanation:
Answer:
A- an Open System
Explanation:
-how dose photosynthesis work on animals and what is it called.
Explanation:
carbon dioxide is it gas that is present in the air plants collect carbon dioxide through tiny holes called Stomates. during the process of photosynthesis, Stomates are also used to expel a gas called oxygen. Oxygen is very important for animals like human -- we need it to breathe !
which model best shows the movement of oxygen during photosynthesis
What is formed when atoms of elements combine? (5 points)
оа
Compounds
Ob
Electrons
ос
Protons
Od
Neutrons
Answer:
Its compounds
Explanation:
PLEASE HELP!!!! 60 points
Answer:
Have a nice Day , I would appreciate it if you could mark my answer brainliest
if 1 teacher cant teach all subjects how come 1 student can learn all subjects ?
Answer:
d
d.d.d.d.d.d..d.d.d.d.d.d.d.d..d.d.d.d.d.d.d
Explanation:
D
Magnesium carbonate decomposes on heating to form magnesium oxide and carbon dioxide as
shown.
MgCO3 → MgO + CO2
How much magnesium carbonate is needed to make 5.0g of magnesium oxide?
А
3.5g
B 4.09
C 6.5g
D 10.59
The amount of 10.5 g magnesium carbonate is needed to make 5.0g of magnesium oxide.
So, option D is correct.
Given that, Magnesium carbonate decomposes on heating to form magnesium oxide and carbon dioxide as
MgCO₃ → MgO + CO₂
Molar mass of MgCO₃ = 24 + 12 + 48 = 84 g/mole
Molar mass of MgO = 24 + 16 = 40g/mole
40 gram MgO is produced from 84 gram of MgCO₃
1 gram of MgO produced from [tex]\frac{84}{40}=2.1[/tex] gram of MgCO₃
Therefore, 5 gram of MgO produced from [tex](5*2.1=10.5gram)[/tex] of MgCO₃
Thus, option D is correct.
Learn more about molar mass here:
https://brainly.com/question/22503632
sandy is looking though a stanstance that that absorbs some of the light waves and others others through. what type of light transmission is sandy seeing?
A. Translucent
B. opaque
C. transparent
D. a substance with color
Answer:
A. Translucent
Explanation:
Sandy is seeing a light transmission through a translucent medium. Or we can say this is a translucent light transmission.
In a translucent light transmission, some of the light are allowed to pass through and some are cut off. An example is frosted glass, tinted glassAn opaque object is does no allow any light to pass through. It simply does no transmit light. An example is paper, leaf and a bookA transparent transmission allows all of the light to pass through.